#MASCHINE CONTROL EDITOR NCM FILES HOW TO#

im Fall, dass Buttons, Regler und Fader Ihres Controllers keine Funktionen in der Software auslsen). Durch die Reinstallation des Controller Editors knnen Probleme mit der Funktionalitt Ihres NI-Gerts behoben werden (z.B.

Dieser Artikel erklrt, wie Sie den Controller Editor reinstallieren.

#MASCHINE CONTROL EDITOR NCM FILES HOW TO#

This article explains how to switch your controller to MIDI mode. Erneute Installation des Controller Editors. Switching to MIDI mode will allow you to use the Host Transport Control. You can control your MASCHINE plug-in when the controller is in MASCHINE mode. Your MASCHINE controller is now configured to use the transport controls in FL Studio. Note: If using a MASCHINE MK1, MASCHINE MIKRO MK1 or MASCHINE JAM, choose your MASCHINE controller as Controller Type instead of Mackie Control Universal. Change the Controller type to Mackie Control Universal.In the Input section, select your MASCHINE controller.In our example picture below, we choose Maschine Mikro MK3. In the Output section, select your MASCHINE controller.Launch FL Studio and insert MASCHINE as an instrument plug-in.Configuring FL Studio for Host Transport Control

You can find more info on using these controllers with FL Studio on this Image Line forum page. Note for MASCHINE MK1, MASCHINE MIKRO MK1 and MASCHINE JAM users: please select FL Studio under Factory Templates instead of Mackie Control before you continue with the steps below. Load the Mackie Control template from the Factory Template drop-down menu.Open the Controller Editor application.Configuring the MASCHINE Controller for Host Transport Control This article explains how to set up your MASCHINE controller to use the transport controls (play, stop, etc.) in FL Studio.

Maschine control editor ncm files